LA Dab Guide

Device help

How to clean a Focus V Carta 2

Updated November 1, 2026

Short answer

Focus V says to deep clean every 25 to 50 seshes. Soak the removed atomizer in 70 to 90% isopropyl for 10 minutes, swab the cup and gold pins, and let it air dry for 1 to 2 hours. Never rinse the atomizer with water. Shake the glass top with isopropyl, then rinse it with water.

These steps follow Focus V's own CARTA 2 cleaning guide.

On this page
  1. What you need
  2. The cleaning steps
  3. Between deep cleans
  4. If it heats unevenly after cleaning

What you need

70 to 90% isopropyl alcohol, cotton swabs, paper towels and a small soaking container.

Flame and alcohol

Isopropyl is flammable. Keep the alcohol capped and away from any torch, stove or pilot light, and do not heat anything until every part is fully dry and the alcohol smell is gone.

The cleaning steps

  1. Power off and let it cool

    Make sure the device is off and cool before you take anything apart.

  2. Clean the glass top

    Pull it straight up from the base. Add 70 to 90% isopropyl, cover the openings and shake for 30 to 60 seconds. Rinse with clean water until no alcohol smell remains, and let it air dry.

  3. Remove the atomizer

    Grasp the lower cylinder and turn it counterclockwise. If it is stuck, run a 15 second cycle at the lowest temperature to loosen the wax, then power off and let it cool completely.

  4. Soak the atomizer

    Take off any silicone parts and soak it in 70 to 90% isopropyl for 10 minutes.

  5. Swab the cup and pins

    Clean the inside of the atomizer cup and the gold contact pins with a cotton swab dampened with isopropyl.

  6. Air dry, no water

    Let the atomizer dry in a clean spot for 1 to 2 hours. Never rinse it with water.

  7. Clean the base port

    Swab the connection port and gold pin on the base, and let it air dry for at least 60 seconds.

  8. Reinstall

    Thread the dry atomizer clockwise until snug. Do not overtighten.

Between deep cleans

Wipe the atomizer cup with a dry cotton swab while it is still warm after each sesh. Focus V also suggests a rice-grain to pea-sized load, slow pulls and starting at the Blue preset, 425°F, all of which cut down on reclaim.

If it heats unevenly after cleaning

Focus V says temperature readings can drift when the atomizer is removed and reinstalled. With the device near room temperature, and below 100°F, power it on, remove the atomizer, power it off, power it back on and reinstall the atomizer to recalibrate.

Store it upright somewhere cool and dry. For storage longer than a few days, Focus V suggests charging to around 50%.

Sources