LA Dab Guide

Device help

Dr. Dabber Switch² flashing lights: what they mean

Updated November 1, 2026

Short answer

Three red flashes means a unit fault, so contact Dr. Dabber support. Three white flashes before a heat cycle means the battery is low. Pulsing red that climbs upward means it is heating, and green means it has reached temperature. Dr. Dabber says most other problems clear with a reset.

These meanings and steps come from Dr. Dabber's Switch² knowledge base.

On this page
  1. Light patterns at a glance
  2. How to reset a Switch²
  3. If it will not charge
  4. If the unit runs hot

Light patterns at a glance

LightMeaningWhat to do
3 red flashesUnit fault: PCB, short circuit, open circuit or chargingContact Dr. Dabber support
3 white flashes before heatingLow batteryCharge it
Pulsing red, climbingHeating upWait
Pulsing greenAt set temperatureTake a long, slow pull
Bottom rear light pulsingBattery at 0 to 15%Charge it
Rear lights pulsing on chargerChargingAll 3 solid means full

How to reset a Switch²

Default settings: with the unit on, press the (d) button 8 times, holding it for 10 seconds on the 8th press. It will vibrate and flash red, green and blue, then power on normally.

PCB reset: with the unit on, hold the (d) button for 15 seconds or more, then let go. It reboots and powers on as usual.

If it will not charge

  1. Leave it on the official charger

    Plug it in with the power switch in the ON position and leave it for several minutes. The low power protection mode can block normal charging.

  2. Power cycle it

    Once the rear lights start flashing, switch the unit off and on.

  3. Run the resets

    Once it powers on, try the two resets above.

  4. Try another cable and adapter

    Try a couple of different USB-C cables and adapters. Once it takes a charge, go back to the official ones.

If the unit runs hot

The top and back can get warm after several uses. Dr. Dabber suggests letting it cool for about 20 minutes after 3 or more heat cycles in a row. If it gets excessively hot, stop using it until it returns to room temperature. Stop using and charging any device that is swollen or damaged.

Sources