LA Dab Guide

Device help

How to clean a Dr. Dabber Switch²

Updated November 1, 2026

Short answer

After each dab, swab the insert with a dry cotton swab, then a swab lightly dipped in isopropyl once it is warm, not hot. For a fuller clean, let the unit cool, then clean the chamber, cloud pathway and crown with 91%+ isopropyl and let everything air dry. Dr. Dabber does not recommend torching inserts.

These steps follow Dr. Dabber's Switch² knowledge base.

On this page
  1. The cleaning steps
  2. The cleaning assist cycle
  3. Mistakes to avoid

The cleaning steps

  1. Swab after every sesh

    Use a dry cotton swab once the heat cycle ends. Wait until the insert is warm, not hot, before using a swab lightly dipped in isopropyl, and keep the bottle capped and away from the unit. You do not need to remove the insert for this.

  2. Let it cool before taking it apart

    Remove the glass first. Never remove the insert while it is hot. Avoid grabbing it by the cloud pathway holes, since quartz and sapphire inserts are very fragile.

  3. Clean the chamber and crown

    Using a cotton swab or paper towel dipped in 91%+ isopropyl, clean residue in and around the heating chamber, cloud pathway and aluminum crown. The silicone seals can come off for cleaning, but take care with the crown seal so you do not damage the magnet.

  4. Clean the glass

    Fill the glass with isopropyl and shake until clean. Add a tablespoon of table salt for stubborn residue. Rinse completely with warm water and let it air dry fully.

  5. Dry everything

    Let every part air dry completely before you use the unit.

Flame and alcohol

Isopropyl is flammable. Keep the alcohol capped and away from any torch, stove or pilot light, and do not heat anything until every part is fully dry and the alcohol smell is gone.

The cleaning assist cycle

You will find it on the app's settings page. It heats the insert to 100 degrees for 30 seconds so swabbing and insert removal are easier. Only run it on a dry insert, never right after an isopropyl swab. Dr. Dabber describes it only as an aid to cleaning and insert removal, and it does not add to the dab counter.

Mistakes to avoid

  • Using isopropyl on the outer shell. Dr. Dabber says it damages the Blue Onyx finish. Use a damp paper towel with a little dish soap, and keep water out of the charging port.
  • Torching an insert. Dr. Dabber does not recommend it, and says inserts are not covered under warranty.
  • Touching inserts during or right after use. They can burn you.

Sources