LA Dab Guide

Technique guide 03

How to clean a banger, dab rig and carb cap

Updated November 1, 2026

Short answer

Swab your banger with a cotton swab while it is still warm after every dab, and most of your cleaning problems disappear. Once a week (or when it looks dirty), soak the cooled banger and the rig in isopropyl alcohol with coarse salt, shake, rinse with warm water and let everything dry. Never pour alcohol into hot quartz.

This is how to clean a banger, a dab rig, carb caps, terp pearls and e-rig chambers, with the swab routine that prevents most of the work, the isopropyl and salt deep clean, what never to do, and a schedule you can actually stick to.

On this page
  1. Why cleaning matters
  2. What you need
  3. How to clean a banger
  4. How to clean a dab rig
  5. Cleaning carb caps and terp pearls
  6. Cleaning e-rig chambers
  7. Q-tip routines
  8. What never to do
  9. A simple cleaning schedule

Why cleaning matters

Dirty gear is the number one reason dabs taste bad. Old residue left in the banger burns every time you heat it, and that burnt taste gets into every dab after. Resin in the rig traps flavor and makes the airflow worse. Old water smells, especially in warm weather.

The good news: most of it can be prevented with a two-second habit. Swab after every dab and you will rarely need a deep clean.

Four panel diagram of cleaning steps: swab the warm banger, soak in isopropyl, shake with salt, rinse and dry
Fig. 1. The basic cleaning loop: swab warm, soak cool, shake with salt, rinse and dry.

What you need

  • Cotton swabs. Lots of them. Plain cotton, not the cheap ones that shed.
  • Isopropyl alcohol. For glass and quartz, 91% or higher works fastest and 70% works but slower. E-rig makers set their own rules, so follow your manual.
  • Coarse salt. Kosher salt or rock salt. It acts as a scrubber.
  • Zip bags or a small jar. For soaking bangers, caps and pearls.
  • Pipe cleaners. For downstems and tight spots.
  • Rig plugs or gloves. To cover openings while you shake.
  • A towel. To set things on to dry.
Flame and alcohol

Isopropyl and open flame do not mix. Cap the alcohol and move it away before you light a torch. Do not torch or heat anything until every part is fully dry and the smell of alcohol is gone. Never light a torch near a soak jar or a wet swab.

How to clean a banger

After every dab: the warm swab

This is the most important habit in dabbing. After you finish the pull, wait a few seconds for the banger to drop from very hot to warm, then wipe the inside with a dry cotton swab. The leftover oil is still liquid and comes right out. Use a second swab if needed.

The leftover oil on the swab is reclaim. Some people save it. Most just toss the swab.

Pro tip

Hold the swab by the very end and twist it as you wipe. If the cotton starts to brown or smoke, the banger is still too hot. Wait a few more seconds.

Deep clean

  1. Let it cool completely

    Remove the banger from the rig only when it is at room temperature. Never put alcohol on hot quartz.

  2. Soak in isopropyl

    Put the banger in a zip bag or a small jar and cover it with isopropyl alcohol. Let it soak for at least 30 minutes. For heavy buildup, leave it overnight.

  3. Add salt and shake

    Add a spoonful of coarse salt and shake gently. The salt scrubs off stubborn residue.

  4. Swab out the bucket

    Use cotton swabs to scrub the inside of the bucket and the arm.

  5. Rinse with warm water

    Rinse thoroughly with warm water to remove any salt and alcohol.

  6. Dry completely

    Let it air dry until it is fully dry and there is no alcohol smell. Do not use a torch to speed this up. Light the torch only after that.

Getting rid of stains

If the banger has dark carbon stains after soaking, try a longer soak with fresh alcohol. Some stains will not come out. Light staining does not affect flavor much as long as the banger is otherwise clean. If staining is heavy and makes heat uneven, replace the banger.

How to clean a dab rig

A rig used daily needs a deep clean roughly once a week. You will know it is time when the water looks murky, the glass has yellow or brown buildup, or the hit tastes stale.

  1. Empty the water

    Pour out the old water and remove the banger and any removable parts.

  2. Pour in alcohol and salt

    Pour enough isopropyl into the rig to cover the perc, and add a spoonful of coarse salt.

  3. Plug and shake

    Cover the mouthpiece and joint with plugs or gloved fingers. Shake the rig gently in all directions. Focus on the dirty spots.

  4. Let it sit if needed

    For heavy buildup, let the alcohol sit in the rig for 20 minutes or so, then shake again.

  5. Clean the tight spots

    Use pipe cleaners for downstem slits and perc holes.

  6. Rinse thoroughly

    Rinse with warm water until there is no salt or alcohol smell left.

  7. Dry and refill

    Rinse once more with fresh water so no alcohol remains, refill to the right level and you are done.

Don't do this

Do not pour boiling water into cold glass. The fast temperature change can crack it. Warm tap water is fine.

Cleaning carb caps and terp pearls

Caps and pearls get dirty fast because they sit right in the oil. Clean them every few days.

  1. Let them cool

    Never soak hot caps or pearls in alcohol.

  2. Soak in isopropyl

    Put them in a small jar or zip bag with alcohol. Let them soak for 30 minutes or so.

  3. Swab and shake

    Shake the jar, then swab the cap holes and wipe the pearls.

  4. Rinse and dry

    Rinse with warm water and dry on a towel.

Pearls are tiny and roll everywhere. Rinse them in a strainer or a cup, not loose in the sink, unless you want to explain to your landlord why there are rubies in the drain.

Cleaning e-rig chambers

E-rigs need a gentler approach because there are electronics inside.

  • After every dab: swab the chamber with a dry cotton swab while it is still warm.
  • Every few days: with the device off and cool, use a cotton swab lightly dipped in isopropyl to clean the chamber. Squeeze out extra alcohol first and let it dry fully before heating. Makers differ on timing: Dr. Dabber has you swab a warm insert, never a hot one, with isopropyl, while Puffco and Focus V also have you soak removed parts. See our pages for the Peak Pro, Switch² and Carta 2.
  • Glass attachment: Clean the glass attachment the way your maker says. Puffco, for example, says to keep water out of the bottom chamber of its glass.
  • Cleaning cycles: some e-rigs have one, and they do not all do the same thing. The Switch² cycle runs at low heat to make swabbing easier. Check your manual before you rely on one.

The full e-rig routine is in the e-rig guide.

Q-tip routines

The most effective cleaning is the one you do every time. Here is the routine most experienced dabbers follow:

  1. Pull the dab.
  2. Wait about 5 to 10 seconds.
  3. Swab with a dry cotton swab, twisting as you go.
  4. Check the swab. If it comes out clean, you are done. If not, swab again.
  5. Toss the swab in a small cup or ashtray, not the trash, until it cools.

Some people use a swab lightly dipped in isopropyl for a second pass when the banger has fully cooled. That is fine. Just never use alcohol on hot quartz.

What never to do

  • Never put alcohol on hot quartz. Isopropyl is flammable and can flash. The fast temperature change can also crack the banger.
  • Never light a torch near alcohol. Cap it and move it away first, and keep soak jars and wet swabs clear of any flame.
  • Do not torch a dirty banger to clean it. It bakes the residue into the quartz and creates carbon stains.
  • Do not use metal tools to scrape quartz. They scratch it, and scratches hold residue.
  • Do not use bleach or harsh chemicals. You will be inhaling through this glass.
  • Do not put glass in the dishwasher. The heat cycles and detergent are hard on it.
  • Do not rinse an e-rig base under water. Ever.

A simple cleaning schedule

WhenWhatTime
Every dabSwab the banger or chamber while warm10 s
Every day you dabChange the rig water1 min
Every few daysClean carb cap and pearls5 min + soak
Weekly (daily dabbers)Deep clean rig with alcohol and salt20 min
Every week or twoDeep clean banger5 min + soak
As neededReplace stained or cracked bangersVaries

If you dab less often, stretch the schedule. The one thing that does not change is the warm swab after every dab.

The LA angle

In summer heat, rig water gets funky faster. Change it every day you dab. And keep your isopropyl in a cool cabinet, not under a sunny window. It is flammable and evaporates quickly in heat.

If your dabs still taste off after a full clean, the problem might be temperature, not cleanliness. Run the fix my dab troubleshooter or check the temperature guide.

Also useful: Carb caps and accessories, Torches and heating, Dab safety, Why is my banger turning white?.

Sources